What are the cleaning steps for industrial chiller units?

　　What are the cleaning steps for industrial chiller units?

　　1. First, disassemble the parts

　　If you want to clean the chiller unit, you must first disassemble it because the components to be cleaned are not easily visible inside the unit. The various parts of the chiller intersect, the circuit is complex, and disassembly is difficult. This can also help to understand the overall structure of industrial chillers.

　　2. Connection between cleaning equipment and condenser

　　After the previous disassembly, locate the water inlet direction of the condenser, connect it to the inlet and outlet of the pump, and then use a tool to heat the pipeline.

　　3. Add cleaning agent for cleaning

　　After each step is completed, after the pipeline is connected, rinse with clean water about 20 times, and then discharge the sewage, repeating 3 times. After cleaning, the most important cleaning agent is completed. The pH value must be maintained between 4-5 and maintained for 2-3 hours. Finally, eliminate the cleaning agent and maintain the pH value of the residual cleaning drug at 6.5.

　　4. Replace to its original state

　　After cleaning, install it back to its original state.

　　Routine maintenance of refrigerant Plumbing includes regular leak detection, regular cleaning and descaling The purpose of leak detection is to prevent waste and environmental pollution caused by the infiltration or outflow of refrigerant; Regular inspections can prevent potential accidents from affecting the normal operation of equipment; Cleaning is to remove the scaling, corrosion and other attachments caused by various reasons in the Plumbing.